Elektric Offroad 2024+ CAN AM Maverick R Trailing Arm Pivot Gusset

When you push your Can-Am Maverick R through rock gardens, big jumps, and desert ruts, the factory trailing arm mounting zone takes enormous load. Over time, that stock pocket can develop fatigue cracks, or the bolt hole can begin to elongate, throwing off the fitment and alignment of your trailing arm pivot. Left alone, it turns into an expensive chassis repair. This reinforcement bracket addresses both problems. It strengthens the trailing arm mount pocket and distributes load more evenly across the frame interface, helping prevent the cracking commonly seen in this area. It also provides a stronger support structure if the trailing-arm bolt starts to open up the mounting hole, helping restore proper fitment and alignment of the arm pivot.

• Reinforces the high-stress pivot pocket where fatigue cracks and bolt-hole elongation typically start under hard off-road use
• 11-gauge mild steel construction for superior weldability and structural integrity
• Provides stronger support structure to maintain proper alignment
• This is a weld-in part, not bolt-in

Fitment:
2024 Can-Am Maverick R Base
2024 Can-Am Maverick R X Base
2024 Can-Am Maverick R X RS Base
2024 Can-Am Maverick R X RS Smart-Shox Base
2025 Can-Am Maverick R Base
2025 Can-Am Maverick R Max Base
2025 Can-Am Maverick R Max X Base
2025 Can-Am Maverick R Max X RS Base
2025 Can-Am Maverick R Max X RS Smart-Shox Base
2025 Can-Am Maverick R X Base
2025 Can-Am Maverick R X RS Base
2025 Can-Am Maverick R X RS Smart-Shox Base
2026 Can-Am Maverick R Max X Base
2026 Can-Am Maverick R Max X RC Base
2026 Can-Am Maverick R Max X RS Base
2026 Can-Am Maverick R X Base
2026 Can-Am Maverick R X RC Base
2026 Can-Am Maverick R X RS Base

Air Freight Prohibited: false
Not Carb Approved: false
Carb Acknowledgement Required: false
Ltl Freight Required: false
Prop 65: Y
Part Type: powersports
Epa: N/A
Units Per Sku: 1
Regular Stock: t